![]() The quickest way to check if pin length is the issue for your side rail’s movement is to add a couple of washers underneath the Allen head screw before installation. Remember we are working with an AK, so there can be variations in receiver width. Because the receiver walls actually flex inward during tightening of the Allen head screws, you want the shaft end of the hex head pins inset into the right receiver wall. So if you are experiencing slight movement of the side rail after installation, remove the Allen head screw from each hex pin to ensure the end of that pin is not flush with the outside receiver wall. The underside of the two Allen head screws must compress firmly against the right outside receiver wall in order to have the adequate compression needed to keep the side rail tight against the left receiver wall. The AK Master Mount ™ side rail is held to the AK receiver wall by side compression. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |